80/105 Front Sway Bar Quick Disconnect kit

80/105 LandCruiser - Front Sway Bar Quick Disconnect Kit

$87.50

Pay in 4 interest-free instalments with Afterpay · Zip available

Model Pre 92
AvailabilityIn-stock orders dispatch in 1–3 business days, usually within 24 hours. Not on the shelf? Allow 1–3 weeks.
Not sure what you need?Call 0421 382 071 — tell us your vehicle, lift and how you use it.

Front Sway Bar Quick Disconnects will give you the best of both worlds for your Cruiser.

Keep both on-road stability & manners, then simply pull a lynch pin & lock the sway bar out of the way, allowing the front end full range of motion to perform properly off-road and in the rocks!


Are you over the seasickness? No longer want to be a sea captain of the HMS Floppy Magoo? This is the kit for you!

Bolt on design that fits underneath the front bump stops under the chassis rail on post '92 models. Simply unbolt the bump stop, slip the bracket in and bolt the stop back in over the top.

Pre '92 models mount between the splash guard and chassis on factory threaded holes.

(Pre '92 models bracket facing forwards. Post '92 models bracket facing backwards.)

New longer hardware included.


Not sure which option you need? The easiest way to tell: if your Cruiser has the smaller rubber bump stop that bolts under the chassis, you need post '92.

If you don't have this bump stop or the mounting holes for it, you need pre '92.


CNC cut 4mm mild steel, coated black. (Custom colours available upon request)


NOTE:

-For pre '92 models:

Please note, the chassis mounts for the sway bar may require some spacers to keep the sway bar off the front tail shaft at full droop.


-For post '92 models:

No spacing required. When pinning the sway bar up onto the brackets, the sway bar may need to be pushed backwards (pivoting on the chassis links) to align with the disconnect bracket.


-We've found an odd difference in some 105s. If the bracket looks too long after install, please reach out, as we have a shorter version.


-The lynch pins provided must be cinched hard to make sure the clip is holding on as well as possible. Please pay attention to this to prevent pin failure and/or loss.


-For those running Superflex/Hyperflex style arms: we cannot guarantee sufficient clearance between the sway bar once pinned up and the arms on full flex, due to the huge number of potential setups out there. It is the customer's responsibility to check if their vehicle's setup requires any alterations to run this product.

(Check how much room you have on full bump/flex.)


INCLUDES:

- Left & Right hand brackets

- Longer hardware

- x2 lynch pins

Complete the setup