80/105 Landcruiser - Race Steering arm gussets

80/105 LandCruiser - Race Steering Arm Gussets

$70

Pay in 4 interest-free instalments with Afterpay · Zip available

AvailabilityIn-stock orders dispatch in 1–3 business days, usually within 24 hours. Not on the shelf? Allow 1–3 weeks.
Not sure what you need?Call 0421 382 071 — tell us your vehicle, lift and how you use it.

Please note: steering arm gussets for competition vehicles. OFF-ROAD USE ONLY


A common failure point with bigger rubber & hard competition driving is where the steering arm bolts to the knuckle. The bolts are known for stretching, coming loose and/or shearing off, even with aftermarket high grade bolts.

These gussets join the arm to the housing permanently, virtually eliminating the load on these bolts.

The knuckle can still be removed from the housing with the arm attached. Just remove the top king pin and bolts and the knuckle easily comes off.

Whilst the knuckle is off you can clearly see, access and change the lower king pin bearings!


KIT INCLUDES:

-x1 6mm P/S Rear Gusset

-x1 6mm P/S Front Gusset

-x1 6mm D/S Rear Gusset


PLASMA CUT PARTS

Plasma cutting will leave a thin layer of nitride on the cut edge of the plate. To assist with obtaining the best possible weld on construction, this layer of nitride needs to be cleaned or ground off. If not cleaned up it can be similar to welding over thin paint. All welded options ordered are cleaned in house before welding, and we suggest doing the same with flat pack orders.


**PLEASE NOTE**

- The factory knuckles & arms are cast. For welding they need to be pre and post heated to avoid cracking or failure.


We offer in house install on these gussets. Providing a nice clean pair of knuckles is dropped off, supply and install is an even $1000. For obvious reasons, we require the studs, cone washers, nuts and spring washers to do the job.

Usually under a week turnaround. Get in contact with us if you require the job done! info@ramptcustoms.com.au

Complete the setup