80/105 Rear Hydraulic Bump Stop kit

80/105 LandCruiser - Rear Hydraulic Bump Stop Kit

$699

Pay in 4 interest-free instalments with Afterpay · Zip available

Options MOUNTS ONLY
AvailabilityIn-stock orders dispatch in 1–3 business days, usually within 24 hours. Not on the shelf? Allow 1–3 weeks.
Not sure what you need?Call 0421 382 071 — tell us your vehicle, lift and how you use it.

Bolt in (almost) hydraulic bump stop kit for the rear end of your 80 or 105 LandCruiser!

Designed to suit the Profender 2.0x2" threaded short body bumps. These mounts will locate your new hydro bump inside the rear coils 30mm below the factory bump height position, meaning it will act as a 30mm extension, with the possibility of 55mm adjustment down. This means you can tweak and fine tune your bump parameters on the rear end of your rig to get the most out of your setup. (Need more than 55mm? Get in contact with us, as it can easily be done!)


95% bolt in design for the chassis. The diff requires additional plating to be welded onto the striker pad for sufficient strength. Plates are included in the kit, as well as the required hardware. The top section of the coil tower needs a 60mm holesaw put through the middle of it to enable the hydro to poke through the mount. A nut plate is included in the kit, which slips up onto the top of the coil mount to aid in installation.


Hydro bumps are a perfect way to really dial in your suspension setup. Unlike rubber stops that can wear out over time, hydros are what we call a true bump, which means once set, they will continue to stop your up travel in that position. They also absorb this force much differently to a rubber stop. Traditional rubber stops build up energy when compressed. Once the compressing force has stopped, this built up energy in the rubber needs to be released, which in the application we're talking about means it pushes the diff back down. In the majority of cases with road going cars this isn't much of a problem, but for someone who likes to get their boogie on, this can emphasise the "bucking" feeling on hard bottom outs. (This is also one of the reasons why you see hydros on all of your favourite race cars.)

A hydraulic stop will absorb this energy without the rebound aspect, or at least with it drastically reduced. You can also tune how this happens by changing the pressure inside the bump, offering more or less resistance. This means these types of bump stops are perfect for anyone who likes to play on the hard side off-road, sees heavy loads, or a little bit of both.



Available as mounts only with the cans welded in, or mounts and bumps.


CNC cut 6mm steel, powder coated satin black. (Custom colours available upon request)


KIT INCLUDES


*MOUNT ONLY OPTION*


  • x2 hydro mounts.
  • x2 6mm CNC cut striker reinforcement plates
  • x2 Nut plates
  • Relevant hardware required


*MOUNTS & BUMPS


  • x2 hydro mounts.
  • x2 6mm CNC cut striker reinforcement plates
  • x2 Nut plates
  • Relevant hardware required
  • x2 Profender 2x2" threaded body Hydraulic bump stops



FREQUENTLY ASKED QUESTIONS.


Q: Will these mounts suit other brand bump stops?

A: To our current knowledge, no they won't, as the body length and the thread both need to be the same for them to work.


Q: Do I need to brace my coil towers to run these?

A: Toyota got a lot of things right, and the rear coil towers are one of them! They are bulletproof, so there's no need for bracing!


Q: Do the bumps come fully charged?

A: Yes they do. They come direct from the supplier, we don't open the box!

Complete the setup