Rampt Long Arm Fix Kit brackets for GQ/GU Patrol, included with the kit

GQ/GU Patrol - Long Arm Fix Kit – Geometry Correction For Long Arm Conversions

$115 $140 Sale

Pay in 4 interest-free instalments with Afterpay · Zip available

AvailabilityIn-stock orders dispatch in 1–3 business days, usually within 24 hours. Not on the shelf? Allow 1–3 weeks.
Not sure what you need?Call 0421 382 071 — tell us your vehicle, lift and how you use it.

GQ/GU Patrol Long Arm Fix Kit


The fix kit that belongs with every Patrol long arm conversion.


Fitted a long arm kit to the rear of your GQ or GU Patrol? Brilliant move for flex, articulation and helping with rear steer — but here's what the long arm kit didn't tell you: the conversion throws two critical geometry figures right out of whack, your instant centre and anti-squat.


Get those numbers back into the right window and your Patrol drives better, transfers power to the ground correctly, and feels more planted everywhere from the black top to the hill climb.


That's exactly what this Fix Kit does.


How it works

These CNC Laser Cut brackets slip straight over your factory upper link mounts on the diff and raise the upper link mounting point — pulling your instant centre and anti-squat back into a much happier place. They self-align off the factory bolt location, so it's a straightforward job: a little grinding, weld them on, job done.

With a bit of love from an angle grinder, they'll also fit an H260 housing.


Dialled in for 3–4" of lift

The geometry is designed around vehicles running 3–4" of lift. If you're sitting higher than that, we heavily recommend dropping back into this range for the best result — your whole rig will thank you, not just the rear end. The kit will still help taller setups, just with reduced benefit.


Fix kit, not a long arm kit

This corrects geometry after a long arm conversion. It pairs with your existing long arm kit; it doesn't replace it.

  • Still on factory lower control arm mounts? Then you're not on long arms yet, and this kit isn't for you. Extended or adjustable lower arms are not long arms.
  • Adjustable upper links aren't required, but we strongly suggest running them to correct pinion angle after a lift.


What's included

  • 2× CNC-cut 4mm brackets
  • 4× spacers
  • All required hardware


Install — roughly 1–1.5 hours

  1. Bolt the spacers to the inside of the new brackets on the top (new) mounting holes. Two tack welds is plenty — that's just to hold them for final fit-up.
  2. Support the diff so it can't roll, then remove the upper links from the diff mounts.
  3. Grind off the flared section at the very top of the factory mount (see photo).
  4. Slip the new mounts over the factory upper link mounts and align the bottom hole with the factory bolt hole, making sure the spacers clear the mount. A little extra clearancing may be needed, depending on the condition of your mounts.
  5. Weld on, paint, and reinstall your upper links as normal.



Prefer we handle it? We offer in-house install — hit us up for a quote.

Complete the setup