Universal lower Panhard mount - 3 Hole

Universal Lower Panhard Mount - 3 Hole

$175

Pay in 4 interest-free instalments with Afterpay · Zip available

Finish FLAT PACK
Bolts NO BOLTS
Axle Tube 76MM
AvailabilityIn-stock orders dispatch in 1–3 business days, usually within 24 hours. Not on the shelf? Allow 1–3 weeks.
Not sure what you need?Call 0421 382 071 — tell us your vehicle, lift and how you use it.

This is our Universal/DIY lower panhard mount, designed to help with building your own suspension link setups.


When converting to a flipped radius arm setup, a solid axle conversion or a 3 link, utilising the factory panhard mount is not something we ever suggest. Panhard length and placement is a little-known but extremely important factor when setting up suspension. This mount is designed to help close that gap and get you a better result much more easily.

3 holes for fine tuning the panhard position. 25mm vertical separation between each hole.

Large surface area for welding & keyed design makes this bracket super easy to construct, and a super strong, reliable mount.


Designed to suit:

3/4 & 7/8" Heim - 16mm bolt (50mm Width)

Factory 80/105 front panhard

Axle tube sizes 76, 85, 89, 92mm


Available in flat pack or welded in house.


DIMENSIONS IN PHOTOS


3 tips to help obtain the correct panhard setup:


  1. Keep the middle of the panhard as close to the centre (left/right) of the car as possible.
  2. When building front ends with mechanical steering, keep the length and angle of the panhard as close as possible to those of the drag link.
  3. Be mindful of moving parts like steering and the different positions the diff housing will reach when under cycle.


PLASMA CUT PARTS

Plasma cutting will leave a thin layer of nitride on the cut edge of the plate. To assist with obtaining the best possible weld on construction, this layer of nitride needs to be cleaned or ground off. If not cleaned up it can be similar to welding over thin paint. All welded options ordered are cleaned in house before welding, and we suggest doing the same with flat pack orders.


***PLEASE NOTE***

Suspension geometry can be a majorly overlooked factor when it comes to link or coil conversions on vehicles. Getting appropriate geometry figures for your build is just as important as, if not more important than, choosing appropriate tyres for your build. We strive to make sure that all builds everywhere are being constructed to the best they can be, to make sure the best possible outcome and driving characteristics are obtained! If you require assistance with your build, hit us up for advice! We are happy to help.

Complete the setup